Local Repairs - Apex & Holly Springs, NC

We have had a lot of success in doing repairs locally using the www.NextDoor.com web site to spread the word of our repair services.  By providing our repair services , we are able to provide you with economical repair services and at the same time, we get access to more things to repair and document for this web site.  We can pretty much fix most anything that has electricity going through it...for example, washers, dryers, dishwashers, garbage disposals, ice makers, electronic ignition fireplaces, HVAC units, HDTVs, etc.

I know sometimes you just don't want to fix it yourself. You may not feel comfortable working with 120 or 240 volts; you may not have all the tools; you may not want to know how to solder; or, you just need to get it fixed fast.  That's where we can help.  As an example of what we have fixed in the neighborhoods of Holly Springs, NC and Apex, NC, we have compiled a list of things fixed locally (these are just a few of the many things we fix)

Email me at duaneharrison113@gmail.com for estimates and scheduling or check out NextDoor.com and call or text me from my listed number there.
 

• Ice Maker Not Working
  Ice makers notoriously break within the refrigerators.  We fix all kinds and styles. Most parts we stock locally so we can fix it right away.  Pictured below are some of the many ice makers which we have fixed.
  
   

  Figure 1 - Some of the many Ice Makers that we fix.
  
   

• Ice Dispenser Not Working
  Pictured below is an LG refrigerator. It was not properly dispensing ice. The ice door flap was not closing all the way (sometimes causing water to drip onto the floor) and it seemed to always deliver crushed ice...wouldn't do cubed ice.  Also shown, is a GE model refrigerator in which the ice flap door isn't shutting.
  
  

  Figure 2 - LG Refrigerator not closing the ice flap door and only delivering crushed ice

  

  Figure 3 - GE Refrigerator not closing the ice flap door (GSS25WSTSS)

  
  
   

• Dryer not getting hot or drying.
  The dryer element or thermal fuse will typically burn out in about 5-7 years, which will leave you with no heat coming out of the dryer. They will go out faster if you do not keep your dryer vent cleaned.  If your dryer vent duct is clogged, this will also shortened the life of the heater element or thermal fuse. Good news is that either of these problems can be fixed.  One of the models that this repair applies to is Whirlpool GEQ9800PW1
  
  

  Figure 4 - Typical Dryer which will not get hot (this one is a Whirlpool GEQ9800PW1)

  
  
   

• Garbage disposal replacement (or repair, if repairable...but most times it requires replacement).
  These garbage disposals last about 5 years. If you are getting close to that time frame and your disposal is giving you trouble, it's probably time to be replaced.
  

  Figure 5 - Typical Garbage Disposal which goes bad and needs to be replaced within about 5 years or so

  
   

• HVAC - Your AC has just stopped working. Your unit outside is not working and inside your house you are just getting warm air blown out the vents.

  The outside fan on the unit shown below just stopped working, causing the cooling to stop inside.  This is a Lennox HVAC unit ( model number 10ACC-024-230-04 ), however, this unit is very similar to all types of HVAC units (not just Lennox). All HVAC units operate the same way...there's not a whole lot of difference between units.  This can usually be fixed without the need for a whole new unit.
  
  
  Figure 6 - Typical HVAC Unit (this one is a Lennox M/N 10ACC-024-230-04)

  See this little video clip describing the problem:

  (see the YouTube video at http://youtu.be/uscZKtwl6j4)

   

• Gas Oven Igniter

  You have a gas oven and it is not heating up.  This is usually fixed by replacement of the igniter inside of the oven.
  
   

• Overhead Stove Lights
  The overhead microwave with exhaust fan (shown below) had lights that the light sockets had gotten brittle and wouldn't hold a bulb and needed replaced.
  
  

  Figure 7 - Over the stove Microwave with bad lights underneath
  
   

• Gear Selector Readout and odometer on Chevrolet / GMC Tahoe Repair

  The gear selector readout and the odometer readout slowing began to fade out. It would sometimes be visible when you first started the car, but eventually it got to where there was no readout.

  
  Figure 8 - Problematic readout from a 2003 Chevy Tahoe.  This one has be restored to its full brightness.

  
   

• Radio Displays gone blank

  There are many radios in cars in which the display just goes blank (everything else tends to keep working). We can fix a number of different types of radios with these blank display problems.

  
  Figure 8 - A typical radio display that has been fixed from a 2007 Ford.